Check the Water Temperature Sensor, Heating Element, and Element Relay. If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, or the heating element circuit has failed, the “F/05” error code will be displayed. If the above does not correct the problem replace the pump.Check the drain pump filter for foreign objects.Check the electrical connections at the pump and make sure the pump is running.Check the drain hose and make sure it is not plugged or kinked.NOTE: After 4 minutes the “Sud” error will be displayed, then 4 minutes later the F/02 error code will be displayed. If the drain time exceeds 8 minutes, the water valves are turned off and “F/02” is flashed. Flow Meter, and Central Control Unit (CCU) Verify wire harness connections to Inlet Valves, Pressure Switch, Drain Pump, Pressure Switch Hose is in good condition and properly connected to Tub and.Check for plugged or kinked inlet hoses or plugged screens in the inlet valves.Make sure that both valves at the water source(s) are turned on all the way.Press PAUSE/CANCEL twice to clear the display. If the control has turned the water valves on and after 8 minutes the flow meter has detected 10.5 gallons of water passing through it but has not detected the pressure switch trip, the valves will be turned off and the error code will flash. If after 30 seconds the control does not detect water entering the machine and then valves will be turned off and the error code will be displayed. No water detected entering machine or Pressure switch trip not detected. Some messages signal that the professional help is required.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |